(1) The semi-reverse flow type bottom blown water pipe is sometimes blocked due to calcium formation, causing ore deposits at the nozzle or blockage of the working gap: if there is such a problem, stop the inspection. Sometimes the blown water pipe is not blocked, but there is some debris in the working gap to make the work gap blocked. The fault phenomenon is that there is no concentrate in the barrel, and the magnetic separator can be inserted into the mine by the pressure water hose at this time. The blockage is washed away;
(2) off magnet cylinder: a cylindrical case of a noise lol, severe skin cut the tube, this time should be immediately shut down for maintenance, to prevent the magnetic blocks off again, a thin copper sheet to be used in the maintenance of the magnetic system Hold
(3) Entering obstacles in the magnetic separator: Lighter will mark the barrel and the heavy one will catch the cylinder or cut the barrel. When this phenomenon occurs, stop immediately to remove the obstacle. It should be prohibited usual bolts, nuts, wire and other metal items fall into the magnetic separator, with the pulp in order to prevent lump ores into the magnetic separator, should block the bulk of the ore and debris in the plus sieve, and always clean ;
(4) Grinding holes in the tank body: If the middle layer of the semi-reverse flow tank or the tailings tube is worn out, the ore will short-circuit into the tailings to raise the grade of the tailings. If the tailings grade suddenly rises and remains high, it can be suspected that the tank is leaking;
The use of wet permanent magnetic cylinder magnetic separator should be standardized:
1. The wet permanent magnet magnetic separator should have full-time personnel to inspect and install the operation;
2. The equipment is installed on a horizontal concrete foundation and fixed with anchor bolts;
3. When installing, pay attention to the vertical direction of the main body and the horizontal;
4. Configure the power cord and control switch according to the power of the device;
5. After the inspection is completed, the empty load test is carried out, and the test can be carried out normally;
The Inflatable Punching Bag is designed on the principle of a tumbler. The exterior is made of PVC and the interior is inflated, which not only ensures the toughness of ordinary sandbags, but also buffers the instantaneous impact of hitting. It perfectly solves the shortcomings of traditional sandbags.
Features of Inflatable Punching Bag:
1. The P&D inflatable sandbag abandons the traditional hard sandbag and adopts an internal inflatable design. The gas squeeze can buffer the pressure caused by the sandbag opponent and avoid hand injuries;
2. The traditional suction cup sandbag will damage the floor and cause the floor to fall off. The inflatable sandbag adopts a water-filled base, which does not hurt the floor;
3. Made of thickened PVC high-density material, strong and wear-resistant;
4. The P&D inflatable sandbag is portable and suitable for multiple scenarios, allowing you to enjoy the feeling of free movement anytime, anywhere, and is no longer bound by traditional sandbags.
Inflatable Punching Bag,Blow Up Punching Bag,Inflatable Boxing Bag,Bop Bag
P&D Plastic Manufacture Co., Ltd , https://www.leadingproduction.com