Second, the engine power is insufficient
1. Ingoing air blockage: Check the air filter, air intake, clean or replace the air filter element.
2. Exhaust back pressure is too high: Check valve timing, adjust if necessary; clean exhaust pipe.
3. Insufficient pressure in booster system: Check and eliminate loopholes in pipelines and connections.
4 , turbocharger work disorders: cleaning or replacement of the compressor shell, turbine shell.
5 , intercooler damage, air leakage: repair or replacement.
6. Oil leakage or blockage of fuel line: Check the sealing condition of the oil pipe and joint, the clogging of the fuel filter, and replace the rotary filter element. Check the spray control seal.
7 , injection pump plunger wear too much: check, replace
8 , sensor bad: check, replace
9 , pressurized compensation pipe damage leakage: replacement
10. Insufficient atomization of fuel injectors: Check fuel injection pressure, clean up carbon deposit, adjust and repair.
11 ã€Advance or late for fuel advance: check and adjust
12. Wrong phase of gas distribution: check and adjust valve timing and valve clearance
13 , piston ring wear is too large, fracture: change
14. Cylinder Head Leakage: Tighten the cylinder head bolt or replace the cylinder head gasket according to the specified torque.
15 , poor valve seal: grinding or worse re-grinding
16 , engine overheating coolant temperature is too high: Check and repair the radiator, thermostat, adjust the fan belt tension.
Polyether Polyols For Polymeric Polyols
The products used in cold-cured,high resilient foam, can increase the compression strength of foam products, improve cell structure and increase the property of foam-cell.
The products widely used in General foam, super high hardness soft foam, hot molding foam,high rebound, half hard foam.
The formulations can be adjusted according to customer requirements.
Polyether Polyols For Polymeric Polyols,Ether Polyol,Caradol Polyols,Polymeric Polyols
NINGBO LUCKY CHEMICAL INDUSTRY CO. LTD , https://www.cnluckychemical.com