The material is evenly fed from the feed port into the vibration groove by the vibrating feeder, under the action of the exciting force generated by the vibration motor in a given direction and the hot air from the wind chamber through the air channel of the vibration plate. Fluidized state. The material transfers heat during the fluidization process, mass transfer, achieves the desired drying effect, and flows to the discharge door for discharge. The humid air is discharged by the induced draft fan and discharged through the dust collector.
application
The machine is widely used in the drying and cooling of powdery and granular materials in the chemical, light industry, medicine, food, plastics, salt and other industries.
Features
1. Reasonable structure, beautiful appearance, high drying strength and wide application range.
2, using dual motor synchronous drive, low noise and long life.
3. The amplitude of the vibration motor can be adjusted steplessly, so that the material moving speed can be adjusted, which increases the applicability.
4, suitable for the drying of crystal and fragile materials, the surface damage is small.
5, good sealing. Prevent cross-contamination of materials from the outside world.
Ford drying can be customized according to customer requirements.
1, the heater can be electric heating, steam heating, burning coal and other combustible heating gas heating.
2. This machine can be used as a cooling device, and can also be used for drying and cooling at the same time.
3. It can be equipped with screening device.
Construction Hoist Steel Structure
Construction Hoist Steel Structure means the construction hoist spare parts like Construction Hoist Mast Section, Passenger Hoist Cage, Construction Hoist Wall Tie and so on.
The length of each mast section is 1508mm, the rack is fixed on the mast by three bolts and it can be exchanged. For the single cage hoist there is only one rack on the mast section, and the mast section can be used for the double cages hoist by increasing one rack. The section of the mast is diverse, select one type section according to different hoist. The mast sections are bolted together with M24 bolts and nuts to form mast. The mast is tied to the building with tie-in and is the guide rail of the cage. According to the user`s or circumstance`s request, surface of mast is hot dip galvanized, which can prevent it rusting.
The tie-in(wall tie) is the linked part between mast and building, to keep the stabilization of the mast. Distance between the tie-in is about 6~9m alone the mast. There are several types of tie-in. Select one of them according to need, tie-in can adjust the vertical of mast in definite ranges. According to the user`s or circumstance`s request, surface of the tie-in is hot dip galvanized, which can prevent it rusting.
The cage dimension(L×W×H)(m): 3×1.5×2.5. We can also manufacture cages of other size according to the user`s needs. The material of the cage and the door material can be steel wire weave, aluminum-plastic panel, punched-plate, figured aluminum board or other type according to user`s needs. The gate is equipped with drawing gate,include small turn over gate.
Construction Hoist Mast Section,Building Hoist Mast Section,Passenger Hoist Cage,Construction Hoist Wall Tie, Construction Hoist Anchorage Frame
SHEN YANG BAOQUAN BUSINESS CO., LTD , https://www.sczenghui.com