2. Before the operation of the valve is started, it must be contacted with the pump station (the pump station should be specially managed) and slowly opened.
3. Operators are required to observe the allowable range of water (oil) press working pressure and are not allowed to work under overpressure or low pressure.
4. When the equipment starts to press, the person is not allowed to lean on the water (oil) press. The operator is not allowed to stand directly under the beam.
5. When pressing or correcting the workpiece, do not hold the workpiece by hand, and do not use an irregular temporary horn or other round rod for pressure pad correction.
6. Heating and heating, must be ventilated before ignition, to eliminate the accumulation of gas, to prevent explosion. Be sure to prevent flames from burning out when burned.
7. When pressing the workpiece, do not hold the workpiece and do not clean the scale. The loading and unloading of water (oil) presses, repairs and lubrication must be performed after parking. Retreat the indenter to a safe position and put the brakes on top to prevent accidents.
8. In the operation of the clamping cylinder switch, you must look at the indicator light, attention should be focused, and irrelevant personnel are not allowed to enter the console, so as not to hinder work and accidents.
9. No open fire or smoking is allowed near the fuel tanks, around the oil pump room and near the gas stoves. Flammable and explosive materials should leave the work site 5 to 10 meters.
10. When running the workpiece, the traffic should be directed by a special person, and should follow the safety procedures of the linked workers and work closely with the driver. The spreader B wire rope should meet the requirements to prevent the wire rope from falling off.
11. During operation, the used tires, molds, and workpiece backing plates, horns should be placed in the center of the indenter and flattened to avoid pressure collapse.
12. Start the equipment and the starter should contact the hydraulic press operator. The signal and meter instructions are clear.
13. The pipeline facilities and electrical equipment shall be repaired under the trench, and the operators shall cooperate with them and supervise them. Running lights should be powered using safe voltages.
14. Use a sledgehammer to correct the workpiece and follow the safety procedures for the fitter.
Checking Fixture For Desigh Service
We focus on checking standard parts for 10 years, located in Suzhou City, Jiangsu provice, China. We reserch a complete checking parts' 3D datas, use our datas to improve effiency and save designers' time, and reduce mistakes. We have the most complete inventory of car checking components. And we passed ISO9001 quality control certification.We also have the ability to design checking&fixtures, make best solutions for you. Our main products are checking fixtures and hold fixture tooling ball assembly, Checking Pins, D Bushings, Go-nogo feelers and slider, mechanism, and so on.
Checking Fixture For Desigh Service,checking design,checking production,control fixture
Kunshan Hongyi Tengda Mold Hardware Co.,Ltd , https://www.hdchecking.com