With oil prices soaring, oil prices have become the most talked about when the owners are idle. How to make your car less oil and run more is a very real problem.
The lack of air pressure will increase the friction between the tire and the ground, increase fuel consumption, so you should always check the tire pressure, different models and tires have different air pressure standards. In addition, if the tire wears heavily, slippage will occur and fuel consumption will increase. If necessary, replace the tire.
Some vehicles will experience a slight drag brake, which means that the load on the car will increase, which will increase fuel consumption. Therefore, regular inspections are required.
Air filters, fuel filters, oil filters, etc. need to be replaced every 5,000 kilometers or more, because the air filter plugging will cause the gas volume to decrease, resulting in insufficient combustion of gasoline and reducing fuel efficiency. The wear of clutch plates and clutch pressure plates and the use of spark plugs for too long can also lead to increased fuel consumption. Therefore, they must be replaced regularly.
According to statistics, every 1% increase in load will increase fuel consumption by 1%. Therefore, it is important to minimize the amount of unused spares in the trunk.
Fighting hard, slamming and slamming on the throttle are all taboos for fuel economy. The fuel-saving test shows that the accelerator pedal is two to three times more expensive than mid-speed driving. Therefore, under the premise of ensuring the normal running of the car, the magnitude of stepping on the accelerator should be appropriately reduced. When you see the red light on or when you get in and out of the highway, you can lightly step on the brakes in advance to slow down and use the remaining power of the engine to let the vehicle slide forward.
The engine runs cooler than the temperature increases, so don't immediately accelerate when it starts. Instead, slow down for a few minutes to allow the engine to warm up before accelerating.
The shift time is as far as possible to choose the 2500 can be in the premise of ensuring the power supply, get a better economy. To stop the low speed and high speed, when driving a manual transmission, the high gear must be replaced immediately after the vehicle speed stabilizes. When driving an automatic transmission, the “sports†mode should be avoided.
Economic speed refers to the most fuel-efficient driving speed, and the economic speed of various models is different. To read the vehicle manual carefully, it will generally be below or above 70, and fuel consumption will increase.
Whether the driving method is correct or not during the run-in period has great influence on the future fuel economy of the engine. Therefore, we must always keep in mind the principle of driving a new car during the break-in period where the speed does not exceed 80 km/h and the speed does not exceed 4,000 rpm. Do not break the ring.
Concrete Vibrator Motor,Electric Frequency Concrete Vibrator,Concrete External Vibrator Motor,High Frequency Concrete Needle
NINGBO MAX MACHINERY CO.,LTD , https://www.nbmaxmachinery.com