GZB high vacuum gear pump relies on the master-driven gear intermeshing the pump body into the suction chamber and the pressure chamber. The oil sucking chamber gradually disengages due to the intermeshing gear teeth, and the working volume of the sealing gradually increases to form a partial vacuum. Therefore, the oil in the oil tank enters the oil sucking chamber through the oil sucking pipe under the effect of the external atmospheric pressure, And with the gear rotation, the oil to the left side of the pressure chamber. On the side of the press area, as the teeth gradually enter into engagement here, the volume of the working chamber is continuously reduced and the oil is squeezed out and delivered from the pressure chamber to the pressure line.
When the motor is running, the propulsion device runs at high speed along with the main shaft. The propulsion device is similar to an axial-flow pump, and the rate of evacuation (evacuation) is far greater than the rate of gear engagement and evacuation. With the propulsion of the propulsion device, Interlocking anti-leakage is blocked, the formation of the ultimate vacuum has naturally been greatly improved, at a lower position of the oil is rapidly inhaled pump chamber, and then by the discharge chamber is pressed into the exit.
When the oil resistance (pressure) exceeds the set safety pressure, the safety valve is activated, so that oil drain chamber oil back to the suction chamber, so as to keep the pressure does not rise, safety valve overload protection.
Search Keyword: More Pumps Technical Articles Valves Pumps Offer information
With the rapid development of science and technology, the use of plastics in modern medicine is steadily increasing. Medical devices made from injection-molded plastics help reduce health care costs, infectious diseases and pain management. High-tech polymers are used in medical device prototyping and are often used to create improved prosthetics and devices to reduce the risk of infection. Medical plastic injection molding directly improves patient safety and the ability to save more lives. High-gloss injection molding: the basic process of high-gloss injection molding is to rapidly heat the surface of the mold with high temperature and high pressure steam before injection molding, so that the surface temperature of the molding mold cavity reaches above the glass transfer temperature (TG) of the resin plastic, and then inject the plasticized plastic melt into the closed mold cavity. During the injection phase, the mold temperature is kept constant by high temperature and high pressure steam. After injection molding, stop the air supply, blow out the steam in the tube with the air pressure of the duct, and then inject cooling water to make the mold temperature drop rapidly, until the mold is cooled and opened to take out the product.
Custom Plastic Parts,Custom High Precision Plastic Injection Molding,Precision Plastic Injection Molding Accessories,Plastic Injection Molding Tooling Parts
Suzhou Dongye Precision Molding Co.,Ltd. , https://www.sjinjectionmolding.com