1, the control circuit should be installed voltage meter, ammeter.
2. Always check if the temperature of the motor is too high (above 70°C) to prevent the motor from burning out.
3, strictly abide by the maintenance, lubrication system, the machine is strictly prohibited sick work, in the event of a failure should be immediately shut down and repair, to be restored before the boot work.
4. It is forbidden to perform repair, oiling and wiping work while the machine is running.
5. The blower pulley guard should be installed reliably and must not be dismantled.
6. The top of the belt between the main motor and the main machine should be covered with wood. There should be a separation wall on both sides. The motor must not be allowed to walk or walk over the belt at work.
7. When the equipment is in normal operation, it is forbidden for personnel to enter inside the main trench.
8. When an abnormal situation or noise is found in the work of the machine, the machine should be shut down immediately, and the machine can be turned on again after the cause has been found out and the problem has been solved.
9. The wire layout should be standardized and reliable, and it should be strictly prohibited from being randomly connected to avoid electric shock accidents.
2. Always check if the temperature of the motor is too high (above 70°C) to prevent the motor from burning out.
3, strictly abide by the maintenance, lubrication system, the machine is strictly prohibited sick work, in the event of a failure should be immediately shut down and repair, to be restored before the boot work.
4. It is forbidden to perform repair, oiling and wiping work while the machine is running.
5. The blower pulley guard should be installed reliably and must not be dismantled.
6. The top of the belt between the main motor and the main machine should be covered with wood. There should be a separation wall on both sides. The motor must not be allowed to walk or walk over the belt at work.
7. When the equipment is in normal operation, it is forbidden for personnel to enter inside the main trench.
8. When an abnormal situation or noise is found in the work of the machine, the machine should be shut down immediately, and the machine can be turned on again after the cause has been found out and the problem has been solved.
9. The wire layout should be standardized and reliable, and it should be strictly prohibited from being randomly connected to avoid electric shock accidents.
S32750 Seamless Stainless Steel Tube
S32750 Seamless Stainless Steel Tube,Seamless Metal Tube,Seamless Steel Round Pipe,Stainless Steel Seamless Pipes And Tubes
Zhejiang Fonye Group Co.,Ltd , https://www.fonye.com