1. Before starting the vehicle, the automatic commercial vehicle needs to place the target in the N position or in the P position. When starting the vehicle, the throttle, hand brake, and foot brake must be matched. After hanging up the D-range, when you release the handbrake, it is also necessary to slow down the brake, and then gently press the throttle. Finally let the commercial vehicle start slowly. It must be remembered that you don't slam the throttle, which not only causes fuel consumption, but also acts as a damage to the commercial vehicle. Be sure to take care not to release the brake pedal while gearing.
2, do not think that after hanging on the D file to start, you can unimpeded the throttle on the maximum high-speed driving. Because automatic commercial vehicles are not fully automatic, when driving automatic commercial vehicles, especially when driving to some road sections that require climbing, the driver must avoid the bad habit of operating in the D-range. When climbing the slope, D will directly feel that the commercial vehicle is not able to accelerate. At this time, you can shift your gear to a position where you can use the low gear to climb a slope. You will not feel powerless, and you will feel particularly relaxed. If you want to quickly accelerate driving, you can switch the gear according to the order of the corresponding gear. When the gear sees the speed of the commercial vehicle expressing a certain value, you need to immediately set the gear to a higher gear, so that you can Good use of the power of the vehicle engine, and you can also reach a faster acceleration effect.
3, automatic business vehicles in high-speed driving, need to keep up with the oil, but when driving in the urban areas are different. No matter how slow you are or how many you open, you basically have to remember to collect oil in time. Especially when the commuting traffic is relatively congested or where there are many traffic lights, if you want to step on the point and feel that it is close to the front of the vehicle, you can only use the brakes on the brakes. This will make the brakes on the automatic car. It is also an operation that increases fuel consumption because of the great loss of the film. At this time, people sitting in the car will feel very uncomfortable and expose their driving skills. In order to save fuel consumption for their own vehicles and to reduce the cost of maintenance, automatic transmissions in the distance saw traffic jams in the distance or remember to collect oil in time after the red light.
Wenzhou Reliabo Culture & Technology Co., Ltd. , https://www.reliabogroup.com