Ai Silu analyzes the operation precautions of the high-low temperature damp heat test box

Posted on



Do not open the door of the cabinet during the test unless it is necessary during the test, otherwise it may cause the following undesirable consequences:
1. The inner side of the door still maintains a high temperature (causing a burn)
2. High temperature air may trigger fire alarm and cause malfunction
3. High-temperature airflow out of the box (very dangerous)
Second, before doing low temperature, the studio should be wiped dry at 60 °C 1h
Third, to prohibit the test of explosive, flammable and highly corrosive substances
Fourth, if the box is placed in a hot sample, the sample power control, please use the external power supply, do not directly use the machine power supply. When putting in a high-temperature sample for a low temperature test, it should be noted that the time to open the door must be as short as possible.
5. Circuit breakers and over-temperature protectors provide safety protection for the test products and operators of the machine, so check regularly.
6. Avoid shutting down and restarting the refrigeration unit in three minutes
7. The lights should be turned off except when necessary, and should be turned off the rest of the time.
8. Please note that the machine must be grounded safely to avoid static induction
9. On any section of the vertical dominant wind direction, the sum of the cross-sectional areas of the test load shall not be greater than one third of the working section at that location.
Ten, when doing high temperature test, when the temperature exceeds 55°C, do not open the cold machine.
Ai Sihao - professional manufacturer of high and low temperature test cases , adhering to the six principles of quality, professionalism, high efficiency, honesty, pragmatism and innovation, has always been at the forefront of the industry, welcome customers to inquire or visit the factory!
There is no good, only better! Dongguan Ai Si in the industry tide, continuous progress, continuous innovation! Product quality checks at every level, for the customer to think, for the customer to ensure. Welcome customers to inquire.

Pipe fittings

Excavator pipe fittings and tube fittings are essential components in the hydraulic system of excavators. These fittings are used to connect hydraulic hoses and tubes to various components of the excavator, such as the hydraulic pump, cylinders, and valves.

There are various types of excavator pipe fittings and tube fittings, including:

1. Flanges: Flanges are used to connect two pipes or tubes together. They are usually bolted together and provide a leak-free seal.

2. Adapters: Adapters are used to connect two different types of fittings or components. They can be male or female, and can be used to connect hoses, tubes, or other components.

3. Elbows: Elbows are used to change the direction of a pipe or tube. They come in various angles, such as 45 degrees or 90 degrees.

4. Tees: Tees are used to connect three pipes or tubes together. They come in various configurations, such as equal tees or reducing tees.

5. Couplings: Couplings are used to connect two pipes or tubes together. They can be either rigid or flexible, and are often used in tight spaces where movement is limited.

Excavator pipe fittings and tube fittings are made from various materials, including steel, brass, and aluminum. The choice of material depends on the application and the environment in which the excavator is used. For example, steel fittings are often used in high-pressure applications, while brass fittings are used in low-pressure applications.

Overall, excavator pipe fittings and tube fittings are critical components in the hydraulic system of excavators. They ensure that hydraulic fluid flows smoothly and efficiently through the system, enabling the excavator to perform its tasks effectively.

Pipe Fittings ,Hydraulic Plumbing Fitting,Hydraulic Pipe Fitting,Hydraulic Tube Fitting

CATSU Hydraulic Machinery Equipment Co.,Ltd , https://www.cattiltrotator.com